Licensed & Insured Contractor in Charlotte Metro
This category covers 18 concrete contractors serving Charlotte metro who carry a valid North Carolina contractor license (or operate legally under the state's threshold rules) and hold active general liability insurance, plus workers' compensation if they run crews. That combination matters more than most homeowners realize: it's what stands between you and a personal lawsuit if a worker gets hurt on your driveway pour, or a shoddy patio that no one will fix once the crew disappears.
What this service covers
Licensed and insured contractors in this list handle driveways, patios, sidewalks, garage slabs, foundations, retaining walls, and decorative or stamped concrete work. The license confirms they've met North Carolina's requirements for the size and type of jobs they take on. Insurance confirms that if a slab cracks from bad prep, a truck damages your lawn, or someone is injured on site, there's a policy behind the claim instead of just a verbal promise.
What to check before you hire
- Ask for the license number and look it up yourself rather than taking a business card's word for it.
- Get a certificate of insurance naming you (or request to be listed as certificate holder) so you can confirm coverage is active, not expired.
- Check that workers' comp is in place if the crew has more than one or two people on site.
- Compare written estimates that specify slab thickness, rebar or wire mesh, base prep, and control joint spacing, not just a flat price.
How our scoring helps
We weigh license status, insurance verification, years in business, and review patterns to rank contractors rather than just listing them alphabetically. For the short list built from those factors, see our ranked guide to Charlotte's best concrete contractors. The full breakdown of how we score and verify each business is on the methodology page.
Get quotes from suitable licensed & insured contractor
No cost, no obligation. Describe your concrete work and we'll connect you with vetted contractors in your area.
All licensed & insured contractor, ranked by score and relevance
34 businesses. The order weighs each business's overall score by how much of its reviewed work is licensed & insured contractor, so a lower-scored specialist can rank above a higher-scored generalist. Filter and sort below, or open the full map view.
Enquiries you submit through our forms may be passed to partner providers who can do the work, and we may receive a referral fee. Our rankings and scores are based on our published method only and are not affected by referral fees.
Common questions about licensed & insured contractor
- How much does concrete work cost in Charlotte metro?
- Most residential flatwork runs in the range of $6 to $12 per square foot installed, depending on thickness, base prep, and finish. A plain broom-finish driveway sits at the lower end, while stamped or colored concrete, extra excavation, or difficult site access push it higher. Get at least three written quotes since prep work and material specs vary a lot between bids that look similar on price alone.
- How often does a concrete driveway or patio need to be redone?
- A properly installed slab with good base prep and control joints typically lasts 25 to 30 years or more before it needs replacement, though sealing every few years and prompt crack repair extend that. Poor drainage, tree root intrusion, or a thin pour without reinforcement can cause problems within 5 to 10 years, which is why base prep quality matters as much as the surface finish.
- What should I expect during a concrete project?
- Expect a site visit and written estimate first, then excavation and grading, form setup, base material compaction, reinforcement (rebar or wire mesh) placement, the pour itself, finishing, and control joint cutting. Curing takes about 7 days before the surface can handle light foot traffic and closer to 28 days for full strength, so avoid parking vehicles on a new driveway until the contractor clears you to.
- How can I judge the quality of a contractor's work before hiring?
- Ask to see completed projects that are at least two or three years old, not just fresh pours, since that shows how the work holds up. Look for even, tight control joints, no significant cracking or pooling water, and confirm they pulled any required permits. A contractor willing to explain their base prep and mix specifications in plain terms is usually a better sign than one who just quotes a price.
Guides to choosing licensed & insured contractor
- Concrete and driveway permits in North Carolina: what you need before you pour
When a concrete driveway, patio, or slab needs a permit in North Carolina, who is responsible for pulling it, and what happens if you skip it.